Protector Guardrail · D228.XBU · 90° · 30×30×8
Ultra X-Base
enquire about this configuration
rotate model
Drag to rotate · click a component to identify it · right-click to isolate or hideDrag to rotate · tap a component to identify it · long-press for isolate and hide
Interactive 3D model of Ultra X-Base · 90° upward · 30×30×8 ballast tiles. Rotate with the arrow keys, zoom with the plus and minus keys, and press Escape to clear the selected part. The parts list on this page names every component and can select, isolate or hide it without the model.
drawing code
D228.XBU.1500.1500.NB
d228-xbu-1500-1500-30-30-08-90
parts
62
assembly mass
157.3kg
enquiries
enquire about this configurationdownloads — no account needed
documents
This family has no drawing sheet of its own — the shared drawings below cover it.
3 declarations of performance set out the wind and imposed-load values for each ballast configuration, alongside the installation manual and the shared technical drawings.
specs
- drawing series
- Ultra X-Base (90° upward)
- module pitch
- 1500 mm
- post spacing
- 1500 mm
- angle
- 90°
- base type
- Ultra X-Base
- ballast tiles
- 30×30×8
- parts
- 62
- 9aluminium
- 9concrete
- 19plastic
- 21steel
- 4unspecified
Ultra X-Base configuration with a 90° upright on 1500 mm post centres, ballasted on 30×30×8 tiles. One module weighs 157.3 kg and covers 1500 mm of edge — 104.9 kg per metre to carry up and lay out. Among the 12 configurations in this family it sits 7th by mass, between 151.8 and 294.4 kg; 9 ballast tiles are 147.8 kg of that, 94% of the assembly, lifted 16.4 kg at a time.
ballast and loading
Derived from this configuration's bill of materials — tile count and part mass as the payload states them, nothing assumed.
- ballast tilesD228.BT.30.30.08
- 9 × 30×30×8
- mass per tilehandled one tile at a time
- 16.4 kg
- ballast mass94% of assembly mass
- 147.8 kg
- assembly mass
- 157.3 kg
- mass per metre of edgeone 1500 mm module
- 104.9 kg/m
Bearing pressure is not published here: it needs the contact area of the feet and a load case, and the published data carries neither. Take the figures above to your structural engineer.
the 90° in this name
90° is the angle the stanchion stands at, measured from the roof surface — the catalogue writes it as “90° upward”. 90° stands the stanchion square to the roof; 70° sets the same stanchion 20° off square. That is the whole difference between this configuration and the 70° version: the two carry the same parts in the same quantities, and the same assembly mass.
Which angle to specify depends on the roof and the load case, and this catalogue does not publish that — see 70° and 90° explained, the declarations of performance on documents, or ask us.
otherUltra X-Base configurations
12 configurations share this family — grouped by ballast tile size.
30×30×8
50×50×5 stacked
talk to us about this configuration
Every drawing, part and figure on this site is published openly — no account, no gated download. Ask us about lead times, quantities for a run of edge, or anything the catalogue does not answer.
designed to protect, built to last